cesoj

Responses from cesoj

Dedicated lines- need break in?
Sine waves in your ac lines are all going to the panel via wires which motors and ballast from lights and harmonics from unfiltered computers will cause the most potential problems. The best thing you can do is to balance the loads at the panel an... 
Circuit Breaker for Dedicated Lines
I am a certified electrician and I will tell you that the breakers should be matched at least in compliance with the manufacture recommended type. Its listed on the panel dead front cover. And yes some manufacturers do make compatible breakers for... 
New B&K Amp Blows Circuit
What load is the amp under. B and K Amps are high current design. And if the load is too low it will tend to keep pumping power until it runs out. When you say you have a dedicated line did you consider the total main capability and the remaining ... 
Amp tripping circuit breaker.
I meant 20 amp not 29 amp breaker. 
Amp tripping circuit breaker.
I am a certified electrician. And I believe part of the problem is the AFCI breaker since it is known to be a common problem with them and GFCI types. Also confirm if you are using a 29 amp breaker with at least 12 awg. Wire otherwise you are over... 
Heavy power cord
Just curious how much audible difference it made to use the cord. Considering that you might have a 1/0 awg. cable connected to number 10 or smaller gauge romex in the walls. Most homes are lucky to even get past 14 awg. Treatment. 
High end car system
My daily driver is a 07 civic si and I am also starting an Acura ilx. 
High end car system
I will look into it I was debating on ribbons for the pillars and thiel midsĀ  
High end car system
http://https//purawphotography.wixsite.com/projectpuraw  
Car Audio
I am building a system into my car using some home based and some car based. I will see how far I can take it within my budget. I currently have installed 2x 12 inch hsu subs into the back seat using an aperiodic membrane and using a tablet as a s...