Is ground noise really normal? If so, why?


I was playing my turntable for my kids tonight and remembering how amazing it is. But the ground noise between tracks was really bothering me and my kids asked what “that noise” was. I can’t imagine it’s not there during the songs. Am I missing something or is audible ground noise completely normal? I’ve had the tech over and I recall he thought it was normal. My turntable is a Clearaudio Performance DC and my phono preamp stage is a P-5xe Twenty. 

If this is normal, why? And are there companies out there that make phono stages that have no ground noise? It’s 2019 for godssakes. 

128x128intermediatic
As others have alluded to the OP should clarify what he means by "ground noise." Hum? Hiss? Something else? Is it present only when the stylus is in the groove of a rotating record, or is it also present when the stylus is lifted off of the record? Or is it present even when the platter is not rotating and the turntable is turned off?

Also, what cartridge is being used, and what gain and input impedance is the phono stage set to? For example, if the cartridge is a moving magnet type and the input impedance is set to 100 or 1000 ohms (the two choices that are provided in addition to the 47K setting that should be used for moving magnet cartridges) it would certainly result in poor signal-to-noise ratio.

But to provide a preliminary answer to the initial question, I would not expect an Ayre phono stage to have objectionable noise levels unless there is something is wrong in the setup or the unit is defective.

Regards,
-- Al

My system is dead quiet..even on phono...I have an all Ayre system with Vandersteen 5A's
Alas, my tone arm is not balanced as I didn’t know it was an option. So while the P5XE feeds the rest of my stack in balanced mode, the tonearm wiring is good old hummy. I’ve to a spool of low voltage wire on the way (remember how great it was to have old radio shack around for that sort of thing?), maybe I can get rid of the noise by grounding the chassis in a few more spots,
Intermediatic, Tonearms (and the vast majority of cartridges) are indiscriminate.  You will have four wires from the headshell plug going either to a DIN plug out or some similar output plug.  If there is a DIN plug or some other similar type of termination at the back of the tonearm, all you need is a true balanced phono cable complete with XLR connectors, and you can then plug that into your Ayre.  There should be a DIN connector (or similar, but typically a DIN) at the tonearm end of the balanced cable.  The maker of the cable will have wired up that DIN plug to carry the signal in balanced mode to the XLRs.  Everything else is the same, NO re-wiring of your tonearm is needed. Get an inexpensive Audioquest or Anti-cable balanced phono cable (specify "balanced") with XLRs at one end and a female DIN plug at the other, and Bob's your uncle. (I specify those two companies only because they give good bang for buck and they can be relied upon not to sell you a single-ended cable that merely has XLR terminations.)
Ground noise is absolutely NOT normal.  I have many receivers and preamps and none of them exhibits ground noise.

Your phono section should be silent between tracks.  With no record playing and your gain turned up it should again be silent.  It’s like that on my Sansui 9090db, marantz 24, 1030 and 7, and completely black on my Phase Linear 4000 series one preamp.

Check your cartridge wiring (some tone arms differ in wiring configuration i.e. SME vs Grace).  Make sure the arm is properly grounded as should be the motor unit of the turntable itself..

Ground noise or hum would drive me nuts.  You may even have a bad cartridge lead.  

N.