Amp change/upgrade for JBL4367 (94dB 2Way with Horn tweeter & 15" woofer)


Currently using Mcintosh MAC7200(SS 200W integrated).  Little soft but zero fatigue. Digital source only, listening mostly mid to low volume, vocal and acoustic music.
 
In mine mind : Mark Levinson 585; Pass INT250; Mcintosh D150orC47+MC452; C2500+MC452
Can some one has actual experience with the above amps give your impression and advise?
128x128kfz03110
I'm sure some one with more direct experience with your speakers can add more but here are your specs. 
  • Sensitivity 1W @ 1m: 94dB.
  • Nominal Impedance: 6 Ohms.
those specs off hand look easy to drive.

You have a wide open world of amplification at your disposal and you don't need huge power 25wpc and up I'd think. 

So something to consider is less power and save some money. I really don't think you'll need 300wpc or close.

I have speakers that are 94db and 6 ohm nominal and run them with 8wps. for example ( granted i'd think 20-30wpc would be idea for my speakers)

I bet a Pass labs class A amp would be wonderful or maybe a Luxman Class A amp. 

No reason to pay extra for all that power if you wont ever use it. IMO

Something to consider.
Thanks. I don’t quite understand the advantage of say: 30 W class A vs a 250W class A/B. Isn’t the class A/B has the advantage of both ? Example:Pass Int 250 don’t leave class A till 15 W and has all the extra class A/B reserve up to 500 W into 4 ohms! Why would a 30 W class A be a better choice over the 250 W A/B???
A few comments:

1)  Power-  For these speakers, at a 12 foot listening distance, 10 watts gives 99 db, 25 watts 103 db, 100 watts 109 db, and 200 watts 112 db.  The OP said he mostly listens at lower levels, where 10 watts would be more than sufficient, but if he wants to turn it up, perhaps to listen to an orchestra at live levels, 200 watts will keep him from clipping at the peaks. 

2)   Totally personal, but for me of the three amps, it is a no brainer, Pass Labs.  I always found them wonderfully transparent.  I liked older Mark Levinson, but they lost me when their Proceed and 331-333 amps started dying early.  McIntosh has never done a thing for me, always providing adequate power, but sounding lifeless.  To me they are the B&W of electronics.  

3)  I would be tempted to try tubes with your system.  Perhaps something like the Rogue Pharoah integrated with a tube preamps section and solid state amp section.  

One thing to keep in mind with Class A amps, high biased Class-B, and tube amps; they all put out a lot of heat and use a good amount of energy.  They make nice room heaters in the winter, but depending on your room, could sweat you out in the summer.  

I own the 4365's and i have found that the JBL's love current. I've tried them with EL34 40w mono blocks, 400w Class D and 50w Class A and the best they've sounded is with the ASR Emitter.