2. tech-talk
  3. 1079579023

xlr and rca on same IC cable??

I'm awaiting a new amp for my HT. (EAD pm 1000). My current setup is using XLRs. The ead only has rca. Changing cables on my Sunfire processor is a MAJOR pain due to it's location. Can I just change the connector on the amp side? If so, Any idea which Neutric # corresponds to the inner and outer parts of the rca?

Thanks
truthrider

Showing 1 response by cadet1

cadet1
50 posts
 
Standard is pin 1 Ground
pin 2 Positive
pin 3 negitive
To go from balanced to rca use pin2 as hot and jumper between pins 1&3 and this is your ground
More to discover