cadet1

Responses from cadet1

Magnepan MMGW/MMGC Receiver and Sub settings?
I have a small magnepan home theater but use the mmgw's as surrounds and MMg's as fronts. I use an integra receiver and the crossover for the mmgw's at 120hz - 150hz. It must be pretty high as they don't go down too far. I set the crosover for the... 
DIY Question: Well Tempered Bearing Cup Upgrade
What wasn't "reliable" about your well tempered? Don't see any way you can combine the two. If you like the clearaudio better, then I would suggest you sell the well tempered and get an isolation base like a Townshend seismic sink or Ginko. My bes... 
Well Tempered Tonearm Problem
I've had one if these for the last 15 years. If there is "way too much up down resistance" then the paddle may be too deep in the silicone cup. Bringing up both sides of the paddle will reduce the damping. The azimuth knob is not a friction fit. t... 
What decibel level do you listen at?
Usually 75-82 db C weighting with my Radio Shack meter. Question? I thought C weighting was for music. Is it not? 
Audio Alchemy DDE 1.0 PS, what is radio shack ver?
You must have a + AND - supply. that's why the stereo mini plug. +, -, and ground. My supply is 12volt DC + - and ground.The radio shack ones I familiar with are only +and ground.I'm guessing the distortion is because of this. 
Volume difficulty with Krell preamp / Adcom tuner
What outputs did you use? If you used the preamp outs,the volume would be affected by the volumecontrol on the Adcom. Tape out is what I would use. 
Blinking red light inside my Proceed AVP2
I don't know what it does but my AVP-2 does the same thing. It must be normal. 
Any good cdp with digital inputs
Quad CDP-2, Excellent sound at a resonable price. 
Help My wife bought me a sub
If you are using no surrounds,why don't you just use one of the RDA 7 channels to drive your sub. Using your RDC 7 to control the crossover freq,level,distance, ect should work very well. I do the same thing with the third channel of my proceed HP... 
Repair,Logan's woofers?
Nick,You lay the speaker down flat with the electrostatic element facing up. Now take a piece of wood and a hammer and tap on the bottom if the wood rails. after you tap them up about an inch or so the rail will come off. You can then see how they... 
Dahlquist DQ-10 : Latest driver substitutes??
I replaced the tweeter and supertweeter with a B&G Neo 3 PDR planer tweeter. Works very well after disabling the supertweeter crossover. However if you are interested. I have one stock tweeter out in the garage. but the planar replacement soun... 
Revel B15 Second Sub Question
The Revel B-15 has an output as well as inputs so you can daisy chain the subs.You would go from processor to one sub and then out of that sub to the other sub. 
Is AES/EBU digital cable/connection all that?
This will probably system dependent. In my own system I have compared AES/EBU to BNC terminated SPDIF cable of the same brand and I prefer the balanced AES/EBU. I have also read others who prefer the SPDIF. I would suggest you try both, if you can... 
Behringer DEQ 2496
Sure, you just need to make cables with XLR on one end and RCA on the other or use adaptors. the owners manual has instructions for doing this. Also it has 1/4 inch phone jacks on the analog ins and outs. you can buy those adaptors at radio shack.... 
What song best sums up the previous year?
For what it's worth. Buffalo Springfield