Would like an opinion on hooking up PC to audio


system by using the headphone out on computer to the auxiliary outputs on preamp. I hooked this up today and found the sound wasn't too bad. All I had to buy was a Y adapter line and connect one end to the headphone out on my computer and the other to my preamps aux. line, using the preamp for the volume control. I use my media center to play and rip my cd's. I am planning to go with Empirical Audio's computer devises down the road, but for now I am going to use this setup. I was just wondering if anybody else has done this and how they think it compare with cd players or sqeezebox or other computer setups for listening. Thank you Sandra
smw30yahoocom
If you like the way it sounds, then it's fine, enjoy. But the stock outputs on computers are usually somewhat noisy (hum, static) and I am sure that you would notice a 100% improvement in imaging, depth, detail, and timbre if you went with an after market digital to analog converter that was somewhat high end (NOT a Soundblaster).

I noticed that much of a difference just going from a mid-fi DAC to an audiophile one.
Hi Sandra. Your approach obviously works but is not optimum. The problem is that on most computers the headphone out is not a particularly good signal source.

It is preferable to get the data out of the computer using USB, Firewire or Ethernet to an external DAC such as the Empirical Audio devices you mention (fabulous but there are much less expensive ways to go) then take the signal from there to the preamp or integrated amp.

This avoids having audio in the computer environment which is very "noisy" because of all the other electronics which are not shielded.
Yes, Studioray, I played some music today and noticed a noisy hum which had never been there before with CD players. It's also very light on bass and one dimentional after listening some more, sounds like I'm using a really cheap CD player in my system. I think I'll just pass on this setup and go with Empirical when he comes out with the newest whatever he is going to have in a few months. (I'm completely clueless when it comes to computers)
Ckorody, what is the less expensive way to go that you mentioned and is it as good as the Empirical Audio sound? Can an amateur like me set it up? Thanks, Sandra
Hi Sandra - I am sure that an amateur like you can set something up - after all the rest of us have managed to =) Suggest you spend a bit of time cruising around Audio Asylum's PC Forum as well as this one.

I find that it is helpful to break the problem down into two parts.
The first part is using a PC hard drive instead of a CD player as the transport. There is a huge benefit to this in that all the jitter associated with CD playback is eliminated. No more complex electro mechanical optical transport spinning imperfect discs in real time at varying speeds. Eliminating the CD player is the biggest single performance improvement.

Using a hard drive as your transport, you are pulling relatively small quantities of data off a drive with full error correction - keep in mind that to a computer audio files are very small and easily managed. You will however need a lot of inexpensive storage, and the discipline to back the drives up.

Ther key to quality is how you encode the data (rip) to the disc. The only satisfactory solution for an audiophool is either in .wav or .aiff or in a lossless format. iTunes and EAC are the premier tools - iTunes is crossplatform and offers a very high degree of integration. EAC is freeware, PC only and has a steep learning curve. There are plenty of people who are happy with each. Some people do .wav but as I understand it there are issues with file tagging (naming) Plenty of info on this on Audio Asylum

Part 2: Now that you have your music on the hard drive, you need to get it to the preamp. There are two things happening here. One has to do with the software that lets you select the music, make playlists etc. We won't touch on that - there are a number of solutions available, iTunes being the most highly integrated and easiest to use.

The big issue for most people is how to get the data from the hard drive to the preamp inputs. There are a number of choices:

#1 - you can put a sound card in your computer and output an analog stereo signal and send that to your preamp. This is almost unanimously considered to be the worst possible way to do it since computers are nasty electrical environments - lots of EMI and RF, switching power supplies, fans etc.

#2 - you can take data off your hard drive and send it to another device using USB, Firewire, Toslink, SPDIF, 802.11g (WiFi) or Ethernet. A few notes here:

• SPDIF smear is the number two culprit you are trying to eliminate (thus the USB DAC) Besides which practically speaking a premium SPDIF cable over 6 feet is brutally expensive. Since you need a soundcard to provide the SPDIF out, you are back to ground zero - plus the DAC is not isolated from computer - more bad. And since SPDIF is not a computer format, it will never be ubiquitous or cheap since PC buyers don't care about it.

• USB is an excellent format for taking data off. There was a wonderful, inexpensive device called a Waveterminal which let you plug USB from the PC into a little black box on the other side of which were toslink and SPDIF outputs to connect to the DAC. Unfortunately it has been discontinued so people are trying a variety of products instead.

A very fine high end solution is a USB DAC, which as previoulsy noted eliminates the need for a SPDIF output and connection. The only downside is that a USB cable goes 15' max - so you have to be willing to have the computer in your listening space.

• Firewire - there are a few devices using Firewire, no real market acceptance. Firewire will go to 30' with a repeater. A lot of people are using Firewire to run their external hard drives for their libraries and backups. Its good but if you can use SATA its much more robust and its faster.

• Toslink - I run a premium glass Supernove 15' from the built in output on my Mac G5 to my DAC. Works very well, much less expensive then a SPDIF of the same length and immune to RFI etc. Of course the Toslink has to be well implemented but I prefer it to my USB>Waveterminal>SPDIF. YMMV

• WiFi - 802.11g This is the wireless standard that Airport Express is based on. Squeezebox also is available this way. Results vary - it is totally environmentally dependent. Tough to beat the convenience though.

• Ethernet - this is the low cost, long distance ubiquitous cabling champ. The premiere device taking advantage of it is the SLIM DEVICES Squeezebox. This is a network device - meaning that it plugs into the Ethernet network just like a computer, printer, router or anything else. This is particularly nice if you have a network (Ethernet or WiFi) connected to the Internet - now you can stream radio without using your computer

To use the SLIM, you install an applet on each computer on your network that has music you want to access. SLIM provides a browser based interface that is organizationally similar to iTunes; as well as access from a remote using the display on the device. (The WiFi version works the same way)

This means that the computer need not be in the same room as the system. Very convenient if you want to support multiple listening areas with a common library. Also note that the SLIM browser can share an iTunes Library - so for instance I can use iTunes to rip and manage my library, iTunes with a DAC in my office, iTunes to support our iPods, then SBs in the bedroom and living room.

There are at least two companies, Bolder and Red Wine Audio who are doing mods for the SB2 and SB3 at very reasonable prices ($400-600). The resulting quality is nothing short of astounding and is delighting everyone who is trying it - myself included. Just a matter of time till someone publishes a shoot-out between the modded SBs and the USB devices. My guess is that unless you have an extraordinarily high quality system you will be happy either way.

Last month, Steve Jobs announced that Apple had sold 14 million iPods in Q4. This means that as more and more people want to use the music they have gone to the trouble to rip; more and more companies will offer ways to do so.

But get your feet wet now. You will be amazed at how good the results are and how inexpensive it is.

Here is an excellent blog on the subject

www.audioasylum.com/forums/pca...

And here are the writings of a very knowledgeable modder - Steve from Empirical - on the benefits of this approach

www.audioasylum.com/forums/pca...

Here is a review of a SB3
www.audioasylum.com/forums/pca...

Finally Srajan has started covering this and had a good kickoff article recently you can find at www.6moons.com

http://www.6moons.com/industryfeatures/harddrive/harddrive.html
Ckorody, thank you so much for this information. I will print it off and read it again (and probably again 12 more times) until I fully understand everything. I do have a PC and will be reading all the other articles you advise to get a good grasp of what I want to do. Thank you again for this helpful information. Sandra
I second ckrody suggestion about the squeezebox. There a nice review on a bolder unit in http://www.enjoythemusic.com/magazine/equipment/0206/midmonth/bolder_modified_slimdevices_squeezebox.htm

The reviewer does a very good job describing the benefits of certain mods. I think for 250 + 400-600 dollars on modifications you get a killer transport and the convience of having all your music at your fingertips. Good luck.