Why little mention of Air Tight on Agon?


My first experience with Air Tight was the ATM-2. A wounderful amp that uses the KT-88 tubes. I now own ATM3 mono amps. Each amp features 6 EL34 tubes. one each 12AX7 and 12AU7 and a superb Tamura transformer. Power rating is 55W in triode mode and 110W in non-triode. ( I use only triode)

These amps are quiet, dynamic, excellent soundstage ( varies with preamp ) firm control of base and great presenentation throughout the range. Voice is extremely realistic and properly placed in the soundstage. They reveal all of the up-front components which has caused be to try many preamps.

I would love to compare these to the new ASL Hurricane recently praised in TAS. As I read the Hurricane article, I could hear on my system exactly what the review described!
OK, maybe not exactly as I was not in his room, but the point is that these are great amps with little mention on Agon. Is it because there are few dealers??

And now for the disclaimer: I am not affiliated with Air Tight in any way - just a satisfied listener.
noble110

Showing 2 responses by tpsonic

I owned the ATM-3s.A nice amp.The supplied EL-34s failed after 6 months.Repleced with AEG EL-34s from Art Monzano-no comparison to the original Siemens I heard.Finally put Siemens in and lasted for five years.Binding posts and attached power cord are not what I expected from a $10K amp.If you think the ATM-3s are good,take a listen to the Lamm,there's another world out there to be conquered.The ATMs are musically colored and not as transparent.You end up paying for the importation and statis,like an Accuphase.Just my opinion,take it with a grain of salt.
Noble110, You might try installing an IEC connector and experiment with power cords.Replace those binding posts and replace the internal wire {I used a cryo'd 35ga. silver },not to mention tube dampers {maybe the Mapleshade}.These mods will improve the tonal neutrality and increase low-level resolution.