Synergistic Research Blue Quantum Fuse (4), ECT (10), PHT (2 Green Dream, 1 Black Widow), HFT (10), HFTX (4), HFT Wide Angle (3), HFT Speaker Kit (2), and Resolution Reference interconnect (2m, used).
Dayton SA-1000 (two), Morel UW1058 10" drivers (4), Precision Ports 3" port (2), and 2 each 1k and 20k resistors. (ie, distributed bass array, aka Swarm subwoofer system.)
Ceramic insulators (3) basically Cable Elevators only off eBay so minus the name brand and markup.
Static Guard anti-static spray. Yes this is equipment. Essential. Try it and see.
And finally yesterday TubeStore Preferred Series KT88 tubes (and 4).
And not bought but pulled out of retirement: Synergistic Research Master Control Center to add Active Shielding to my speaker cables, and interconnects, and motor controller. Black Diamond Racing Shelf for the SR MCC and about 21 BDR Cones for the subs, amps, and MCC. Two ElectraGlide Fat boys. These half meter power cords run 18" straight into the Dayton amps, the whole setup being very low profile and centered between the speakers right where "Jim states" they shouldn't be.
I plan on adding some more ceramic insulators, until all my cables are off the floor and run nice and neat. Still have 2 BDR Shelf to go under the amps. Rosewood veneer to finish the subs. Build a solid low profile stand for the amps.
Hey I did nothing, no cleaning no nothing, for 5 years. At least. This is catch-up.
Dayton SA-1000 (two), Morel UW1058 10" drivers (4), Precision Ports 3" port (2), and 2 each 1k and 20k resistors. (ie, distributed bass array, aka Swarm subwoofer system.)
Ceramic insulators (3) basically Cable Elevators only off eBay so minus the name brand and markup.
Static Guard anti-static spray. Yes this is equipment. Essential. Try it and see.
And finally yesterday TubeStore Preferred Series KT88 tubes (and 4).
And not bought but pulled out of retirement: Synergistic Research Master Control Center to add Active Shielding to my speaker cables, and interconnects, and motor controller. Black Diamond Racing Shelf for the SR MCC and about 21 BDR Cones for the subs, amps, and MCC. Two ElectraGlide Fat boys. These half meter power cords run 18" straight into the Dayton amps, the whole setup being very low profile and centered between the speakers right where "Jim states" they shouldn't be.
I plan on adding some more ceramic insulators, until all my cables are off the floor and run nice and neat. Still have 2 BDR Shelf to go under the amps. Rosewood veneer to finish the subs. Build a solid low profile stand for the amps.
Hey I did nothing, no cleaning no nothing, for 5 years. At least. This is catch-up.