What Could Cause Center Image To Present Lower than Expected


I will preface with admitting, that I am not an audiophile, but a hobbyist at best. Purchased Totem Acoustic Forest Sig. I am powering them with a ModWright  KWH 225I with Morrow Audio Sp7 speaker cables. My primary source is an Ayon S10 MKII network player/DAC feed by Small Green Computer (ROON) with Snake River Audio Mumushi Sig XLR interconects.

Integrated/Player feed with Morrow Audio Elite Power cords from a Shunyata PS8 w/Defender. PS8 connected with Shunyata Alpha v2 NR power cord.

Room is 13x19. Speakers 7' apart and 4" from front wall and 2.5' from side wall. No toe-in.  Audio equipment behind speakers along short wall with TV above mounted to wall. There is an 8x10 decorative rug hung on wall behind tv/equipment.

From the get-go, I have been very happy with sound and center image / soundstage present without fiddling with anything. Better than my ATC SCM19 v2.

My issue is with how low the center image presents.  Not sure how to proceed. Where to start. Is it most likely a speaker adjustment or component issue? I know my room is not properly treated.

Scott

amboguzzi

Showing 1 response by audphile1

Play with speaker positioning. Moving the speakers closer together will usually make the center image more pronounced but will sacrifice on soundstage width.

Spreading the speakers further apart will widen the center image and soundstage but at the expense of losing some of the focus.

And definitely move them out into the room about at least a foot away from the wall behind them. You can also experiment with raising the speakers off the floor slightly. You can use platforms or nobsound springs from Amazon to experiment on the cheap.

Create an equilateral triangle between your listening chair and speakers. It’s all room/component dependent.

Find placement that strikes a good balance. And if the problem persists, then you need to continue working on room acoustics and potentially revisit your components.