If you must do this, use Cardas binding posts at the wall plate and high quality spade lugs on the remainder of the (short) run to your speakers.
Better yet, simply pull your existing cables through a hole in a decorative plate and leave the terminations as they are.
It is not possible to cut the wires, add solder joints and connection points without some loss. The question is whether this is going to be audible on your side channels.
Better yet, simply pull your existing cables through a hole in a decorative plate and leave the terminations as they are.
It is not possible to cut the wires, add solder joints and connection points without some loss. The question is whether this is going to be audible on your side channels.