2. amps-preamps
  3. 185579-150037

Using biwired cables on speakers with only 2 connections

I generally have bought biwire speaker cables in the past, and now I have speakers that can't be bi wired.

Is there any problem if I only use two of the four wires and just Cover the other two wires so they don't touch each other. I hate the fact that I bought really expensive speaker cables and now I have this issue.

Do I use the high pass or the low pass LR pair?  Which have been marked this way so I trust there was actually a reason for them doing this and not just cosmetic

Will this impair sonic performance ?

emergingsoul
yodogyodog
14 posts
 

Never seen an 11.5awg wire before 

audphile1's avatar
audphile1
4,922 posts
 

Use banana to spade adapter. Search amazon. 

motorbykemike
4 posts
 

Piggyback banana adapters are available 

 

they have one make that would plug into the speaker in your case , two females that you would plug both the high and low sides of the biwire into , most often one of the females is angled 

jhnnrrs
110 posts
 

Biwiring is nonsense anyway.  The two sets of terminals were originally for bi-amping, bi-wiring is the product of a bored audiophile with an active imagination.  Just leave the extra connections off and cover them with electrical tape to prevent shorting.  Of course someone will tell you that the kind of electrical tape will make an audible difference.

markpao
519 posts
 

 

yodogyodog-

My speaker cables are 11.5 awg

 https://www.kabusa.com/frameset.htm?/spiralvoice.htm

More to discover