When you responded to my previous post, I edited it, sorry!
A general rule of thumb is that the amplifier input impedance is at least 10 times higher than the preamp output impedance to provide a flat frequency response.
Using 2 Amps with Audible Illusions Modulus 3A Preamp
I want to have 1 amp driving the woofers and the other driving the midrange and tweeters. Can I use a y adaptor coming out of the main set of outputs, or should I use the second set of outputs, which I believe has an additional cap in the circuit. Unlike some out there, I have never had my AI unit burning through tubes. ( I have only used the specifically recommended Russian ones or Tungsram, over the years)
5 responses Add your response
According to the Audible Illusions Modulus 3A manual, its output impedance is 1.2kΩ. It is best to check that the input impedance of the two power amplifiers paralleled should not be lower than 12kΩ, otherwise it may cause low-frequency roll-off. https://www.allaboutcircuits.com/tools/parallel-resistance-calculator/
|
