Two Channel HT

I can biamp with my hk avr7550hd by setting the avr to 5-channel stereo mode. You then have to set center channel to off and speakers to large and no sub. So then the right front and side have the same full signal and the left front and side have the same signal. '

You might have to connect a tv in order to make these settings.

Thanks, Kr2. I'll have to get my NAD 7600 out of the closet, I guess.

Thanks, again.

RH

I am afraid that your older receiver is ill-equipped to do what you want. It does not support A/B speakers or remote zones. Also, what comes out, even via the main speakers is not really controllable without an on-screen display.

You would have been better off with a 2 channel/stereo AVR.

Thanks, Kr4. Yes it works great as a 2 ch when surround is off. I do not want surround, simply speakers in another room operating as stereo. I do not have it hooked up to the TV, thus no screen instructions. I'm working and don't have the receiver to say how the pair 2 speakers are connected.

Thanks for your interest.

Is it working correctly as a 2 channel receiver?
Do you want to add surround speakers?
Have you followed the setup procedures in manual and on-screen menus?
How have you connected the "satellites" and how have you configured them?