Tweeter protection
Hello, I have a few sets of B&W 800 series speakers and I'd like to install an inline fuse to protect my tweeters. My question is; should I go with 125v or 250v 1 amp fuse? Open to suggestions.Thanks
1 A seems a little low. https://www.rapidtables.com/calc/electric/power-calculator.html Though honestly not sure that anyone would use a tweeter protection circuit anymore. Depends on the rest of the crossover. If the HP filter is low order (i.e. slow rolloff) then it’s more critical, assuming you aren’t trying to overpower the speakers or overdrive the amplifier to begin with. AFAIK, a lot of the cylindrical fuses do both 120 and 250V, the important part is the current in this case, as the voltage from one side of the fuse to the other is nearly identical. That is, you wont’ have 120V across it, and frankly 120V is already overkill, so make yourself happy. 120V across an 8 Ohm tweet is about 1800 Watts. :D |
