Thanks for sharing!
Tripp-Lite Spike Cube
I was recently left without a Power Conditioner/Surge Protector for my main system and looked through my stash to see what I could put together. Found the Furman AC-215A which is a very good unit with SMP protection and LIFT linear filtering. Unfortunately, it only has two outlets which I ending up using for the FM Tuner and CD Player. Having nothing else available, I plugged my Integrated Amp into the same duplex outlet as the Furman and plugged the Subwoofer into a separate outlet.
As configured, this left the Integrated and Sub with NO protection. From past experience I know that inexpensive conditioners (especially those with series inductors) can “current-starve” amps and subs with an adverse effect on sound quality. There are power conditioners available (AQ Niagra 3000, etc.) that employ Power Factor (energy reserve) technology to address this problem but they’re simply outside my budget.
I was looking for a low-cost solution and remembered that I had a Tripp-Lite Spike Cube that I had used in another application. The 600 joules of surge protection that it offers is provided by “sacrificial” MOVs with a small capacitor added for noise suppression. I like the fact that it’s plugged directly into the outlet and the equipment to be protected is plugged into the Spike Cube. There is no power cable, On-Off switch, fuse/circuit breaker or any component in series with the AC supply.
I grabbed the Spike Cube I had and checked the resistance with a DMM from the male plug to the female receptacle and found only 0.1 ohms on the Hot, Common (Low) and Ground. Wirecutter did a teardown of the Spike Cube (see link below) with impressive results.
I then did some critical listening with and without the Spike Cube on the Integrated and found absolutely NO sound degradation. In fact, the sound was slightly better with the Spike Cube, which may be attributed to the line filter capacitor. For those who plug their power amps (or integrateds) directly into an outlet because of dissatisfaction with power conditioners in general, this might be a low-cost ($10) way of providing some protection without taking a hit in sound quality. If nothing else, you’ll sleep better knowing that your equipment is protected.
8 responses Add your response