Tri - Wire with Bi - Wire: Which to Bridge?

I agree with the Synergistic guy, however with one possibility of result. It might create a speed problem in the bass.Try it and see if you hear any bloating or slowness in the sound. If so, switch the jumpers from the mids to highs with the NBS cables going to the lows & mids.

I’ve read where that is the correct way to do it with a three way speaker but I’ve not experienced it myself. If you had a two way and a single run, you’d connect to the bass and jump up.

Some say to cross them can get better results (for you, one side connect the upper two and the other, the lower two, jumping both to the remaining posts (only vertically!)

I was told to try it with my two way speakers and did, but discovered that going from the bottom and jumping up (as recommended by the maker) sounded best. You won’t know until you try.

All the best,
Nonoise

I tried both-- amp leads to highs/mids with jumpers mids-lows is best.  Thanks gents.

Is there a best way to connect a three way with three binding post pairs using two jumper pairs?

jb not sure but i'd guess coming in on the highs