Email or call Townshend. It should be on the website.
If you need a contact, PM me.
Bob
Townshend Isolda Speaker Cable BI-WIRE issue
I recently tried the Townshend Isolda speaker cable and I was blown away. I love it. So much I bought a second to Bi-Wire them together as that is how I had my last cable setup.
However, when Bi-Wired, the system breaks down in audio quality. The bass extension is lost, and the music feels like something is missing. Almost like entire frequencies are missing. It's strange.
I did try both cables separately, to confirm that both cables were good on their own, and they are. But when Bi-Wired, they don't sound anywhere near as good. For the record, I am using PS Audio BHK mono Amps with Revel f228be speakers.
Does anyone have experience bi-wiring the Townshend Isolda speaker cables? Any ideas why this could happen? Any suggestions? Any science?
4 responses Add your response
@csr78 - what amp are you using them with? When I looked up the specs on this cable - it stated that the capacitance is 3,100pf
3,100 pF is pretty high and some high current solid state amp designs DO NO like high capacitance speaker cables
If you are using tube amps then they should work fine - because tube amps are not bothered by high capacitance speaker cables. Regards - Steve |
I figured it out!
You can't run both cables near each other. They interfere with each other. There is no shielding on these cables. I'm not sure exactly why, but basic principles of electromagnetism could explain why I heard frequency dips. Just basic constructive and deconstruction forces maybe.
I was careful to keep them away from the floor and other cables, especially power cables, but not from themselves. Separating them brought all the sound clarity I was hoping for, and placing near each other again repeated the problem. |