2. cables
  3. 127608-3037

To Bi-Wire or use Jumpers?

Looking for suggestions. I just purchased new speakers the Klipsch Heresy 111 special edition and was wondering if i would benefit from bi wiring or just get jumpers. My gear is,  Primaluna Premium Dialog HP integrated with my source being the Sony HAP1ZES. The speaker cable is Tellurium Q entry level silver which i was using with my previous Dynaudio speakers. Interconnect is DNM. If i bi wire, looking at Audio Quest Castle Rock, Audience Conductor E and maybe ClearDay cables. I would welcome any other suggestions. As far as jumpers, not sure, never used them. Thanks for any feedback.

Brian
brian27b
chrisr's avatar
chrisr
542 posts
 
The jumpers add 0.003 ohms to the overall load, so they are not a consideration to decide single vs bi-wire.  It just depends on the speaker.  I would get a pair of starquads from canare or mogami, or audioquest if you have a preference for solid core, and try both ways.
jmcgrogan2's avatar
jmcgrogan2
6,346 posts
 
@tls49 , +1.
I believe that the person who you are referring to is the legendary Al (almarg).

As others have said, biwiring may help, and it may not. It all depends on system synergy and personal tastes.
ayonsinha
11 posts
 
Always prefer bi-wire if gauge and length are the same. With bi-wire all you are doing is doubling the amount of conductor resulting in way lower resistance for the low voltage DC current. Jumper with 12awg cables vs Bi-wired with half thickness cable will give you almost identical results. 
Go for the most amount of copper and high quality plugs where the conductors are joined. Largest amount of contact surface will give least conductive resistance. 
ayonsinha
11 posts
 
Brian27b, since you asked about the plugs, here what matters is the amount of surface contact area and how tightly they can be connected. There should be no possibility of tiny sparks (almost invisible due to low voltage) at the contact points.
i would go with Monoprice banana or spade. Either way you’ll be fine. What you are looking to do is avoid any weakest links in your setup. Any thin wire or loose connection is a weak link. All you have to do is provide good amount of current flow conductors without interference from strong magnetic fields or loose fittings.
Ag insider logo xs@2x
cleeds
5,715 posts
 
ayonsinha1
.... With bi-wire all you are doing is doubling the amount of conductor resulting in way lower resistance for the low voltage DC current.
Huh? What DC current are you talking about? If you have DC on your speaker cables, you have a problem.
More to discover