2. speakers
  3. 1224979609

There is a Bi-amp function in my A/V Receiver.

Greetings all,
I just discovered that my Pioneer Elite Receiver has a biamp set-up feature using its own unused back channel speaker terminals. It still puts out a full range signal though, so the high and low taps on my speaks will still get the same signal. Is there any merit to doing this. Or could it be harmful to send a full range signal to the tweeter section of my Klipsch Epic CF3's. Or does the crossover still cut out any part of the signal that could be harmful.
Thanks,
shiva
5 responses Add your response
dweller's avatar
dweller
3,781 posts
 
My Onkyo 876 also allows this. I can also "bridge" the two channels for greater power (alas, the speaker must be 8 ohms -sorry Thiels).
Your speaker's crossover will pass only the frequencies the tweeter can handle (assuming your speaker came with the bi-wire terminals connected (some kind of metal strap or jumper wires?).
stanwal's avatar
stanwal
3,147 posts
 
Don't forget to remove the jumper if you try this. Otherwise Dweller is entirely correct. All it will cost is another set of speaker wire and there is a good possibility of better sound
Post removed 
zieman
339 posts
 
I have never had to disagree with Elizabeth, but here goes: Bi-wiring produces different results with any speaker. It seems to have more to do with the crossover than anything else. I have bi-wired several brands of two ways that showed a tremendous improvement.
shiva OP
181 posts
 
Thanks for the replys. They are now biamped and it does add to the sound. I have had them bi-amped before to good effect, but then, only the lows and highs were going to each set of taps. It was the full range signal going to each that made me pause.
Log in to respond
More to discover
80x80
Kharma dB9-S
80x80
Ascendo GmbH Live 15 - silk matte black finish
80x80
Revel Performa F206