2. amps-preamps
  3. 159359-9984

TAD M2500 amp - Power Cord warning

Hi Everyone:

I would like to upgrade the power cord thats connected to TAD M2500 amp with one of the aftermarket power cord from either Audioquest or Siltech(Ruby Mountain). My question is 2 fold (The inlet on the amp is 2 pronged).


1. I see the following statement in the user manual for m2500. 

        • Although the power cord to the unit is removable, do not attempt to use a power cord other than the supplied cord.


Why would they print such an explicit warning? I tried to see some pictures/videos when this amp was used in a TAD demo room, but couldn't find any that shows which power cord is connected during their demo.


2. My second questions is, can I use c15 plug to connect to this amp, even though the inlet is only 2 pronged. I think my second question could be already addressed here.

https://forum.audiogon.com/discussions/diy-power-cable-questions
sandeepk100

Showing 1 response by erik_squires

erik_squires
16,639 posts
 
1 - Usually this is because those power cords can be unusually thin gauge.  So long as you stick to 12 gauge you'll be fine.

2 - Yes.  If your amp has 2 prongs, it is double insulated and does not require the ground safety wire.  however, shielded power cables still can reduce RMI / EFI noise.
More to discover