@no_regrets Yes , i have used a Entre ET100 SUT wiith a Roksan Reference phono which is solid state op amp based and i prefer it better than through the MC setting in this phono stage.
SUT into MM input section of Solid State Phono Stage
Hello,
I was wondering if any of you have experimented with using your Step Up Transformer into the moving magnet section of your solid state phono stage?
If so...
what was the step up ratio you used?
what was the mV output of the cartridge you used?
which solid state phono stage did you use?
did you find that the SUT into the MM section sounded better than just using the moving coil input without an SUT?
I ask because I just experimented with using my Tango SUT into the MM section of my solid state Forte FP-1 and have found that I prefer that over just using the MC section of the Forte.
Best Wishes,
Don
I was wondering if any of you have experimented with using your Step Up Transformer into the moving magnet section of your solid state phono stage?
If so...
what was the step up ratio you used?
what was the mV output of the cartridge you used?
which solid state phono stage did you use?
did you find that the SUT into the MM section sounded better than just using the moving coil input without an SUT?
I ask because I just experimented with using my Tango SUT into the MM section of my solid state Forte FP-1 and have found that I prefer that over just using the MC section of the Forte.
Best Wishes,
Don