2. analog
  3. 125139-22888

sub 2k phono stage

I am running a moving magnet into a sonic frontiers pre-1 P tube preamp - using the phono stage only via the tape outs into a passive preamp.  The question I have is whether a newer stand alone phono stage such as those offered by rogue, etc- new or used - would best an older unit such as this.  For those of you who are not familiar with it I believe it is on par with an audible illusions. 
majorc
4 responses Add your response
majorc OP
76 posts
 
My passive is a modified QED MA-34.  Running it to modified quicksilver M60 monoblocks.
john_tracy
341 posts
 
Is your passive pre resistive (resistors) or is it inductor based (TVC or autoformer)? The output impedance of the phono pre (lower probably better) could be an issue depending on the design of your passive unit. If so, SS or tube units with line out transformers will provide lower source impedance to your passive pre.

stanwal's avatar
stanwal
3,147 posts
 
I have had some very good ones but as I am downsizing my system I am going to get a Jasmine. 

yogiboy's avatar
yogiboy
5,661 posts
 
Some stand alone phono preamps do not supply enough voltage to drive a power amp directly. If you go that route just make sure the phono preamp you choose will supply the voltage needed. BTW,it also depends on the output voltage of the cartridge you are using!
Log in to respond
More to discover
80x80
Kuzma Stabi R
80x80
ZYX Ultimate Exceed Astro
80x80
Technics SP10 MK2 with 2 tonearm included