2. digital
  3. 167672-162373

Streamer Advice / Recommendation for Denafrips R2R DAC

I really could use some help / recommendations on the choice of a streamer.  Here's where I am in my research:
I've decided on a Denafrips Pontus DAC (R2R) because of it's sound characteristics (musical while maintaining definition).  It is within my budget, while the Terminator is not.

My current thinking is I need a streamer that does not have memory, amplification or a DAC on board.  I will use the streamer-DAC pairing to listen to music in a AVR / Music setup: Denon AVR3700H (105 watts) connected to a Rotel 1590 power amp through the Denon precouts.  Bowers & Wilkins 702 S2 (left right) speakers.  Bowers & Wilkins 802 center channel (power connection by Denon amp)  SVS and Yamaha powered subwoofers. When used for streaming Netflix it's a 7.2 setup.

For streaming music I listen to the usual list of suspect: Tidal, Qobuz, Spotify.  In it's current setup, the system is too bright and harsh.  Speaker placement is in the room from acoustic hell: rectangular 15' x 45' with the front/ center channel speakers facing the narrow width (unfortunately by necessity and I'm in the process of adding reflection panels to cover 15% of the room.

I am determined to achieve music that does not wear me out after a couple of hours listening: well produced electronic music / R&B  / piano jazz.  I like midrange dominance but without too much detail in the +8k hz.

I learned to budget more for the DAC than the streamer, but most of the streamers I've looked at are combo amp/hard drive/DAC or they have networking into multi rooms. The  Auralic Aries G2.1  is out of my budget by about $2,500 (at 5,100 US), Willing to pay more for great sound but am unsure the streamer makes that much of a difference than the DAC.

Advice? Setup Recommendations?



pmreagan2

Showing 1 response by tony1954

tony1954's avatar
tony1954
1,209 posts
 
@pmreagan2    

"Now it’s a matter of figuring out how to transition my components from a primarily theater setup (being frank about it) to a primarily music/ theater system."    

Not sure if you are still in need of someone else's "2 cents", but I had the same issues you have and they are now solved.    

What you need to do is use an integrated amplifier with a HT (home theatre) bypass. This will allow you to run your home theatre setup through the Denon, but the two channel system will run through the integrated amp. @Soix is correct that the Denon is the weak link. It isn't that the Denon isn't a good AVR. It is the fact that AVR's are inherently inferior to integrated amplifiers or other two channel setups. My previous system was built around Cambridge Audio's top of the line CXR200 AVR, but it just wasn't doing it for me.   

To fix things, I purchased a Musical Fidelity M6si that has a HT bypass. I sold the CXR200 because it did not allow for separate output of the front left and right channels and replaced it with a Anthem MXR520.    

Now I run all the HT components through the Anthem and all the two channel through the Musical Fidelity. I was even able to separate the power by running all the two channel power cables into a separate power conditioner.


More to discover