Speakers for leading edge, transients, speed and big sound


Hello- I am looking to spend about 20-30k on used speakers ( guessing they would have been -40K new a few years back). Any suggestions welcome. I have a 14*20 room and I am looking for dynamics, potentially a great sounding horn or equivalent. Excited by Tektons but since I have the budget wondering if there's anything better. I did have the JBL M2s that I really enjoyed and Revel Salon 2s that I didn't so much

Thank you!

saummisra

listening to Monitor Audio Platinum 200 3G speakers continue to put a smile on my face. Detailed with depth and articulation. Hooked up to Pass, Esoteric and a VPI classic…

I would recommend one of the Vivid Audio speakers.  If you want great leading-edge attack, jump factor and dynamics, but don't want the drawbacks of horns, I'd go for Kaya K90, K45, or Giya G3s2.

Jay's Audio on Youtube announced this weekend that Von Schweikert speakers are comparable to Sonus Faber and Magico if they had a baby, high resolution, huge dynamics, huge soundstage and musicality.  Even the new VR 30 speaker with a pair of 10" VS subs can fill a large room or balance a small room with the adjustable (not in DSP/digital domain) subs permitting easy speaker placement and fundamentals to shake your room. 

@faustuss Wrote:

faustuss's avatar

faustuss

127 posts

 

@ditusa Bill Woodman who founded ATC in 1974 solved this problem by using "underslung" edge wound voice coils in a longer and tighter gap which eliminated the "offset" issue while reducing distortion up to 20dB throughout the driver's frequency range. In addition, this reduces the usual swings in impedance as well as radical changes in phase angels resulting in flat impedance response without resonances. The caveat being the need for enormous magnet structures along with considerable reduction in efficiency. Essentially though, you could use any type of amplifier typology to drive their speakers without harm to the amplifier but to get the speaker system to come alive you need minimally a hundred watts high current solid-state power.

Thanks for the post. Remember Bill Woodman and Edmond May see heresmiley

Mike