Solid state to tube


I have been a solid state guy since my start in this hobby. Over the years I have built a few systems and have used mainly older YBA seperates pre and power for my front end.

I also have a pair of musetex MT101 mono blocks from Meitner audio which I use as well.

My speakers are reference 3a lintegre

I am thinking of moving to a all tube system 

. However I have little experience

I have looked at Quick Silver and a small boutique builder called Will Vincent. Have not heard anything yet. I thought I might inquire here first for any suggestions from tube savvy members

ecpninja

Showing 1 response by bpoletti

It's my opinion that small signal music seems better handled through tubes though there may be some tube noise in very small signals like LO moving coil cartridges amplification. 

It seems to be more of a toss up as the signal strength increases through amps.  Then it's how good the designer is and how their equipment is voiced.  My preference is for a particular type of solid state amp design.  But my preamp is all tube and phono stage is hybrid.