2. tech-talk
  3. 164480-157369

rule of thumb: how long do you leave a tube preamp on versus turning it off then back on?

I just upgraded to an Audio Research REF 10 with 12 tubes and I am wondering how to best preserve the tubes. How long sitting turned on is equal to the wear and tear of turning it off then on again? I had a Rogue RP 7 with just four tubes so I didn't worry about this issue so much, I just turned it on when I began to listen then off at the end of the evening. Now I'm wondering where the sweet spot is? Away for a hour, two, three, turn it off when? Am I over-thinking this issue?
128x128wokeuptobose

Showing 1 response by yogiboy

yogiboy's avatar
yogiboy
5,653 posts
 
+1 @ millercarbon

HOW DO I KNOW WHEN MY TUBES NEED REPLACING?

Power tubes like EL34’s and KT88’s are good for about 2500 hours or more. But may go longer in an amplifier with a conservative design. Small signal tubes with numbers like 12AX7, 12AU7, and 6922, and rectifier tubes like 5AR4 may go 10,000 hours. So you get years and years of enjoyment. Using a tube tester may or may not tell you if you need a replacement. The best approach is to buy a new set of tubes, and install them. If they don’t sound a lot better, put in the old ones and suck every bit of life out of them.




More to discover