Review: Acoustat Model 2 Speaker


Category: Speakers

To this day I remember the first time I heard Acoustat Speakers,they were the 1+1. Until that time I thought I had heard the best there was. But those Acoustats just literally blew me away. Thats tough for me to say being the jaded audiophile I am. However due to the 1+1 height of nearly 7 feet I just couldn't use them in the house I had at the time. What a disappointment that was. However a couple of year later the Model 2 came out. Same panels but this time mounted side by side instead of vertical. Now that I could use,in the house I had.

So the review here will be of the Model 2 Acoustats. I have never been disappointed in the sound of the Acoustats. I listen mostly to Jazz,Classical and Rock. The Model 2s always deliver the music with astonshing clarity,detail and depth. For me the most important aspect of a speaker is to deliver the music as close as possible to the orginal studio recording and the Model 2 truly excel in this area. In fact at times damn near startling in their presentation. I have as usual been searching for speakers that could truly out class the venerable Model 2. Have listen to every Planar speaker out there,and to this day have not found any to warrant replacing the Model 2. And for going on 20 years now that speaks volumes on these speakers.

The weakness of the Model 2 is that they need power at least 100 per channel.They are also dipole. You have to really tune them to the room their in. And once every few years the interfaces need to be serviced. Also if the rest of the system is not up to the task,the Model 2s are unforgiving.

Once a few years ago I did audition a pair of Martin Logans for a week in my home. The MLs were very good,but to my judgement the ole Model 2s were just as good.If the MLs had truly outclassed the Model 2,the I would have paid the $3,500.00 for the Martin Logans.

So the search continues in this field.

Specifications
Frequency Response:35-20K + or - 2dB
Sound Pressure Level:105 dB @ 15' in a 12'x18' room
Minimum Power Requirements: 100 Watts RMS
Nominal Impedance:4 Ohms
Power Consumption: 5 watts 120V60 Hz
Control:High Frequency Balance above 10K Hz
Dimensions: 58"x20"x3 1/2"
Weight:64 pounds each with interface.

Associated gear
Acoustat TNT 200 Power Amp,Acoustat MRP PreAmp,Denon DCM 370 CD Player,Denon DP 61 F Turntable.

Similar products
Magnepan,Martin Logans,EROS,Vandersteen,etc.

ferrari
Looking for good amp to drive Acoustat 22 properly, other than the TNT-200...any ideas
The new Hafler designs using Jim Strickland's design should be good. Tube amps are out, at least the Audio Research amps never had enough current to drive the Acoustats, they always sounded underpowered with no bass. I'm sure Krell, Levinson or other high current solid state amps would work as long as they are stable into 4 ohm or lower load. The old Hafler DH-500/200 never sounded good with the Acoustats either.
I just bought a pair of Acoustat Model 2's and am seeking the manual. Might you still have it available for sending?

Thanks in advance,

--Adam