Removal of Optimus/Lineaum dipole tweeters

It appears that there are 3 screws holding the "tweeter assembly" down (left/right/rear) on the LX-5.The LX-10 appears to have the left/right screw hold-down,but has a flange affixed over the wiring coming out of the cabinet.
If loosening these screws,can the tweeter assembly be removed safely and intact? Thanks in advance.

Thank you Elevick and Ait.Have the LX-10s in pieces.Ceriously considering a switch to the Aurum Cantus 7" drivers.Will be replacing components in the crossover and rewiring.
Two questions:
(1) Would I be better off with "new" cabinets/better built?
(2) Are the tweeters exactly the same on the 5/5ii/10s?
Thanks for the help and advice-in advance,Tom

It appears that the Aurum Cantus 7" DVC midwoofer may be a perfect mate for the Lineaum.The cossover will be 6db/oct at 5Khz.This will further protact the tweeter and require one element per side.A single cap/tweeter and an inductor for the woofers.I will initially use the same cabinet with added "stuffing".With the 6db rolloff of these woofers,they will be down 12db at 10Khz.
I have a choice to make,as to wiring.I have Omega Mikro ribbon,or some cryo'd 18ga copper/woofer and 22ga silver for the Lineaum?
Any thoughts??

The Aurum Cantus DVCs are on their way,along with a .11mH inductor.Will be using dual 6db/oct crossover at 5Khz.

Anyone willing to comment on damping the cosmetic plastic covers on the LX-10s? (front face)
Has anyone found a better alignment on the dipole tweeter?
Forward or further back yield better results?
All comments appreciated-thanks-Tom

Thanks Ait. Any use in "hot-glue" and damping in the front plastic panels?
I am using a first order X-over at 5Khz.I decided to use the same capacitors that I used in the DIY speakers that I built previously:PAS 4.0Uf with the V-cap .01 as bypass.I bought the cross-coil 16ga ribbon inductor from Jantzen,as it was a similar ribbon design as the Omega Mikro.
I am going to experiment with moving the location of the di-pole Lineaum,as I have heard the benefits of this in the custom Gallos and the DIYs built before.I had thought about doing this prior to the "mods",but decided that it might be fruitless.