I was able to lower surface noise by a pretty large amount by replacing stock VPI Classic feet with GAIA II feet. I thought things were pretty well isolated on a 3" maple block with isolation pads in each corner. Obviously, pops and clicks are still present but the static/rumble type of groove noise was reduced by 10dBs on average (measured a lead-in groove before and after). So isolation can help with perceived background noise. And there are inexpensive ways of isolation if you don't care how it looks.
Reducing Background Noise On Records
Hello. I'm looking into ways of reducing background noise on LP recordings. Some of my records just have a lot of noise (most likely from how they were recorded). My system consists of a Yamaha DSP-1A integrated amp, Pro-Ject Debut Carbon turntable (acrylic platter equipped) with an Ortofon 2M Blue Cartridge. My speakers consist of a pair of Wharfedale Rubiance RB-27's in the front and RB-23's in the rear with a Mirage FRX-S15 powered subwoofer.
I recently integrated a DVD 3BX-DS into my system to improve the impact and dynamic range of my records. Should this be sufficient or are there other devices (such as the KLH Burwen Research DNF 1201A Dynamic Noise Filter) that can better reduce the background noise of my records in question? By the way, I do clean my records with a VPI HW16 record cleaning machine and rinse off the cleaning fluid twice with distilled water. I also use a Zerostat 3 to remove static before playing a record.
What do you think?
I recently integrated a DVD 3BX-DS into my system to improve the impact and dynamic range of my records. Should this be sufficient or are there other devices (such as the KLH Burwen Research DNF 1201A Dynamic Noise Filter) that can better reduce the background noise of my records in question? By the way, I do clean my records with a VPI HW16 record cleaning machine and rinse off the cleaning fluid twice with distilled water. I also use a Zerostat 3 to remove static before playing a record.
What do you think?