2. amps-preamps
  3. 1218129367

Quicksilver MC Step Up Help

Just purchased a used on from here at Gon. Setup is Scout with Shelter 501->Quick silver MC Stepup->PSAudio GCPH->Preamp

No output at all, (without the MC sound is normal) Qucksilver comes with the outpur RCA cables pre-attached, I have then hooked up to the phono amp.

Coincidently QuickSilver is in hte process of relocating to California and are closed, Waiting for seller to respond. Any help is appreciated.

regards
-BisP
bpuhan
7 responses Add your response
Post removed 
bpuhan OP
4 posts
 
Viridian

thanks for the pointer/corection,(it meant 100ohms), I will try your sugegstion later today. Once question though, even if the load and gain are not matched, should I not still get some kind of sound ?

regards
-bisP
Post removed 
bpuhan OP
4 posts
 
Tubegb,

The gain is 60db on GCPH with my volume control on GCPH all the way up, my preamp id 18db, As the output of the catridge is only .4mv.
My logic is to put a stepup to so I do not have to use the full volume on the GCPH.

regards
-BisP
tubegb's avatar
tubegb
190 posts
 
Hello,

I could be missing something here, but if you're connecting to the moving coil input of the PS Audio GCPH you should not also be trying to use a pre-preamp or step-up device. The PS Audio unit would/should be designed with enough gain to accomodate your moving coil cartridge direct.
bpuhan OP
4 posts
 
thanks for your comments,

PSAudio GCPH is at MC gain and at 100K ohm setting, I did not connected the scout ground to Quicksilver input ground, will this could be the trouble ?

regards
-BisP
Post removed 
Log in to respond
More to discover
80x80
Pass Labs XP-22
80x80
Yamaha A-S3200
80x80
Audio Mirror Wave