2. amps-preamps
  3. 148712-122106

Power on popping sound

Hi Everyone!

Why does the left speaker always make a "pop" noise when the amp powers up?  Also, after preamp and amp are powered up there is a low buzz coming from the left speaker.  Not sure if I can hear the buzz from the right speaker.

The left speaker also makes a "whoosh" sound when powering off the amp.  

Getting paranoid about speaker damage.

Gear:
Speakers:                    Ologe 5 (Same thing happens with my LS 50 passives)
Amp:                            Forte Audio 1A 
Temporary preamp:     ADA Suite 8x8 - (I might pick up an Audible Illusion Modulus 2B but am open to suggestions.)
I also swapped in my Fostex HP A8 as a preamp and got the same popping and buzzing.
Rocket 88 speaker cables

Thanks!





hleeid
7 responses Add your response
hleeid OP
219 posts
 
I reversed the cables.  Turns out it is the left channel. Thanks Yogiboy!

Checked out the amp repair site. I'll get in touch with them on the buzzing and pop sounds.  What a great resource!

@firstnot - What amp are you using with your Audible Illusions 3?

Is it better to use a tube amp with a tube preamp? 



firstnot's avatar
firstnot
248 posts
 
Love your Audible Illusions choice. If you are patient you can get a newer
3 series for $1,000-$1400. Not sure what the 2 series go for. I bought one in November on a tip from a wise man. Very Musical.
tls49's avatar
tls49
1,351 posts
 
The Forte Audio 1A is a great amp, however it does have some age and should be serviced. The absolute best person for the job is Jon Soderberg at http://www.vintageamprepair.net  After his service, it will likely perform and sound better than it did when new. He was a service manager at Threshold when the amp was introduced for sale. 

hleeid OP
219 posts
 
Thanks for your help! I will try reversing the cables and also the LOFO steps.

Is the power supply capacitor an expensive thing to replace?
tomcarr
1,511 posts
 
In addition to the excellent advice from the above posters, always remember LOFO (amp is last on, first off). Turn-on sequence should always be: source(s), pre-amp, amp. Turn-off sequence should always be amp, pre-amp, source(s).

Tom
kalali's avatar
kalali
1,977 posts
 
Assuming the problem is isolated to the amp which will most likely be the case, try turning on the preamp a few seconds before the amp and see if you still hear the pop. You probably will not. As for the whoosh sound, its most likely the power supply capacitors that are near their end of life. My very old Adcom 545 did it too.
yogiboy's avatar
yogiboy
5,671 posts
 
Reverse the speaker cable going to the speakers. If the problem goes to the right speaker then you will know that left channel of the amp is the problem!
Log in to respond
More to discover
80x80
Decware ZMA
80x80
VTL TL5.5 II
- Vacuum Tube Preamplifier
80x80
Pass Labs XP-32