Power Cord Length

Cha ching, cha ching -- it's music to the ears of the cable
salesman with the cash register. IMHO it's pure nonsense.
Jay

It depends on the cord and gauge. In any case you need to get power to where ever the component is so your stuck there. Anyhow I think the best thing is to get a good power center with a big capacitor in it and have it near the components. or a little one like the ps audio ultimate outlet and have it near the sub or whatever so then run a short cord off of it. This will provide a little power in resorve by the componment so if it draws alot there is a bit in reserve A larger guage power cable also helps here for the same reasons. Vs. running a long cord from the power center to the component.

If you are just coming from the outlet just get a decent shielded cord.

If your power cords are shorter than 5 feet, aliens from the planet Gammar can use them as antennas to transmit subliminal messages through your audio system. This is in preparation for their planned invasion in 2007. If you are using a short power cable, shield it by wrapping with Rhodium foil.

Gotta go now....it's medication time!

Okay...I wasted my undergraduate tuition for my physics degree if I said anything other than "a power cord needs to be longer than 5 feet to be a clean conductor? What are you smoking?!"

What I *have* heard, though, is that some manufacturers (myself included, when I used to put together my own lab cables) use particular kinds of casings and antistatic/insulators that can actually pinch the conducting core if the cables are so short that their curves are of some, often small, angle or less (pinching). Thus, if you have a cable of "sufficient length" cabling loops are allowed, as long as they're not too tight. This generally describes home-grown, and often *cheaper* cables, though, not high end lab/mil spec/a/v cables...

I seriously doubt that such precarious storage/use requirements were employed by the company you used: after many years in a lab, I've only used one material - a flexible carbon fiber-aluminum hybrid - whose characteristics for best signal passage demanded relatively unkinked runs. It cost ~$2200/6". Thus, unless that was one, well, really costly power cord, I'd say it is unlikely a realistic concern for you.

Sheesh...

Seriously (if there is such a thing in this hobby??), I 'm sure some of us will be led to believe there is truth in this (marketing reasons or otherwise) but the link below does suggest digital cable lengths are affected by it, not sure about PC though since it is not passing signal/information??
spdif

Oops....the link below suggest digital cable lengths are affected by it........
http://www.positive-feedback.com/Issue14/spdif.htm

Mahalo to everyone for your input. I can buy into Ivyinvestor's explaination of cable pinching. There maybe some stiff high end cords, which require more length to provide for gentle curves to meet installation needs, but otherwise I'll keep using with the shortest power cables possible.

just a guess here but it seems to make sence...if there is any sence to be made spending big $$ on power cords. In an article i read about using the house electric service to run computer network signals they indicated that they put that signal into the higher frequency range since the noise on the system resides in the lower frequency. My guess is that some of the high end cords are acting as high pass filters to some degree so that the noise is removed before it gets to the amp. A longer cable may increase the efficiency of the filtering?

it seems to do with attenuation of high frequencies energy, as the noise amplitude in those Mhz range gets weaker when distance travel gets longer.

5ft is optimum for good signal flow and filtering.

ebm01-21-2016 12:37pm"5ft is optimum for good signal flow and filtering."

Could you please explain what you mean by "signal flow?" Other than a cable that is of high resistance because of insufficient gauge, what would constitute bad "signal flow" in a power cable?