phono cable for VPI SSm

If you use balanced cable it is DEAD quiet...even with volume control up and an ear against the speaker.

You can run any shielded cable but you may need to run a separate ground wire from the TT to the phono stage or you may produce a hum/buzz.

Anyone can tell me if I need a dedicated phonocable (with a ground wire) or can I use a regular IC whereas my setup include the BMC MCCI phonostage to which you should not connect a ground wire. Anything to do with the need of the cable to work with low signal such as the output signal of a TT ? Is there a requirement for a shielded cable with low output signal ?

I use Morrow PH6 Grand Reference cable on my Super Scoutmaster Reference rimdrive with excellent results.

Clear day Audio makes unbelievable silver interconnects as well as speaker cables. You can find him on Audiogon. The cables are a steal and Paul is a great guy. He even lends them out without even a deposit. You don't want it, just send it back. No money has been spent, only the cost for priority mail.

I'm using Anti-Cable silver balanced with my Superscout into Ayre....with a smile.

No I haven't. I bought my Table from Elusive Disc and it is what Bob Bantz recommended. He said I could sell you a more expensive cable but there is really no reason to spend more money as the VPI does a great job.

Czbbl

Did you try other Ics against the VPI one ?

I use VPI as well .........

I use the VPI cable for my traveler and it is as good as my Harmonic Technologies silver phono cable.

I use the Audio Sensibility Statement Silver Phono Cable. It uses Ohno Continuous Cast (OCC) silver with a purity of 99.99998% (7N).

http://audiosensibility.com/blog/products-2/phono-cables-occ-copper-and-occ-silver/#/!/~/product/category=3749226&id=18243484