Oppo 105 and Power Amplifier Input Sensitivity


Novice here and needing some advice! Yesterday, I picked up an Oppo 105 to use as my pre/pro for a dedicated 2-channel listening setup. Until I get a set of XLRs, I am using the unbalanced RCAs. I was reading that the output on the oppo is 2.1V unbalanced and 4.2V balanced. I am running the Oppo straight to my Krell S-275 which has an input sensitivity selectable, 2.4 V or 4.8 V - stereo. Using the analog volume control, could I experience clipping that could blow tweeters or my amp? I have read about the 15x rule of thumb on input impedance, but what about the input sensitivity? The Krell is powering B&W Nautilus 804S's. I just want to be sure I don't have to worry about watching the volume when I'm tying one on! ;) Again, sorry for the noob questions. I'm usually a safety third type of guy, but not when it comes to my precious equipment, Ha! 
bconman
I'd put the amp on the 4.8V sensitivity and then you should be able to run the Oppo, but before you put in a CD, turn the volume down!
The Krell input is 2.4V unbalanced and 4.8V balanced. The Oppo is 2.1V and 4.2V respectively. I was just reading about spikes that could cause clipping at high volumes. People were talking about using attenuators to reduce the Oppo's output Vrms...??
Yes. You could run a Passive Volume Control too. If you go that route, keep your cables short! IME they tend to rob some of the bass impact if less than full volume; that's why I prefer other means. 
Wouldn’t wouldn’t using the 4.8 Volt input throw away a lot of costly power potential?