New Project RS2T transport

Hi Folks. I'm new to this forum having discovered it while researching issues with my RS2T transport.

I was interested to read lpretiring's post of 01-03-2023, having experienced an identical issue with my unit following a power cut. I was able to restore functionality in the same way by looping through several off/on cycles.

My unit also has an intermittent  'skipping' problem - it can work OK for weeks, then lose tracking to the extent that a CD loses playability and the transport has to be restored with one or two off/on cycles. Having read the posts on the forum, it is clear that the RS2T has issues, and that my thoughts that spikes in the mains power supply might be responsible are unlikely to be true.

Looks like the unit has to go back. I'll keep you posted.

@astronomer63 

I've lost power several times this year with my RS2-T always being in standby mode. It now seems the best approach under these circumstances is to just leave the unit on. When I first encountered an outage with the unit in standby, I would switch it off awaiting power restoration. Is that the way you handled the situation?  That was when I had problems powering up. The last few outages I leave it alone and when power returns the unit is on awaiting a disc to load. I then return it to stand by and this has worked I believe 3 times now. I've never had a problem coming out of standby to on.

With the 2 units I have had I never experienced random skipping that then shuts the unit down. 

You paid for a perfect working unit and should be permitted to exchange for just such a player.

    LP

Just saw this thread, and wanted to contribute some definite solutions…

First, I must say from the outset that this is the best sounding CD "player" I’ve ever had (and that includes some serious devices like the Naim CDS3 and Micromega T-Drive/T-DAC in the 90’s).

But there are issues :

1) Can’t read a great number of discs (especially CDr). Defective clamp?

This was really frustrating, as I own a lot of these. The puck just doesn’t sit properly on the CD, Meaning that there maybe a variation in the thickness of the discs.

A fixed this by adding 3 layers of self adhesive tape at the bottom of the puck. Thickness may vary, but it now works with 100% of discs.

This is temporary solution, but it’s fine until I tidy it up :-)

2) Screen Flashing

This was corrected with a firmware update that can only be done by a trained technician. Pity the upgrade didn’t replace the terrible clip art graphics :-/

3) Top lid is difficult to handle.

You really need a 3rd hand, when you are trying to place the disc.
This was fixed by attaching a very light self-adhesive rubber piece on one side. It is now easy to raise the lid with one finger..

If anyone experiences the unit not playing check the door’s micro switch. Mine wasn’t making good contact and wouldn’t turn on. So I bent the switch tab up higher so it hit the door better. Now it’s working fine.

my remote just died! Anyone have any suggestions?

I changed the batteries. I replaced the IR LED but no luck.

i checked behind the front panel by the receiver LED didn’t see anything wrong.

Anyone have any suggestions??

Bob7296       Thanks for the update. I was the one that initially started all this.

I couldn't agree more, it is the best I've ever heard, and not just for the money!   I'm on my third one,  from the music room. They were great to deal with, and checked my third one before they shipped it. So far so good. My puck had a small burr on the inside. I removed it an its been just fine.

I actually hope they (project) work out the bugs and start shipping NEW ONES that have been future proofed. They have a gold mine, and don't know it!!!!!