Matching SUT for Benz Micro MC Gold


I think that the Lukaschek PP1-T9 should be an ideal match but they sell for @ $1,500. With an internal impedance of 20 ohm a regular mc SUT with loading options should be more than enough at this level.

Any recommendations?
f456gt
Klyne and Uesugi Bros....nice :)
Cart loading is very preamp dependant so if you have never used the Uesugi phono section it will involve several unknowns. (Best load, and if higher ratio sut into lower sensitivity input or lower into higher sensitivity input sounds best- and yes that affects load)
You could probably buy and try and sell a few sut based on vintage mic trafos ( ebay etc) without much $$ lost at the end and learn from the experience.
End of the day i use Silvercore often...





I had a Klyne Series Six with a MC phono stage but I sold it. 
Actually, I am using a Uesugi UBROS-1 preamplifier: PHONO 1 and 2 - (2mV / 47 kΩ); PHONO 3 - (6.5 mV / 47 kΩ).

Not enough gain to drive a LO MC cartridge.
Cheers,
The question is WHY do you need a SUT instead of quality MC phono stage ? 
Bellari MT-502 ($499) and a good half-meter IC. I have one and am very happy with the SQ! Made in the USA, too!
I searched for SUT with variations for future changes, finally chose this vintage Fidelity Research FRT-4

https://darklanternforowen.wordpress.com/2021/01/01/fidelity-research-frt-4-mc-cartridge-transformer...

I got a lot of SUT advice in this discussion that helped me make that choice

https://forum.audiogon.com/discussions/which-sut-for-3mv-10-ohms-mc-cartridge-into-3mv-mm-input-sens...


................................

That cartridge has an elliptical stylus. I enjoyed elliptical for a long time, however:

I suggest you consider a cartridge with an advanced stylus: MicroLine, Shibata, SAS. 

Perhaps a MM cartridge now, hear the advantages of that stylus upgrade,

or a MC with advanced stylus, similar output to your Benz so a chosen SUT will handle either.

...................................







Decware makes a couple different ones, with a trade-in program so you can exchange as needed for different cartridges.