Magnum Dynalab Magic eye


Hello,
The magic eye on my Dynalab MD 108 no longer works. I have dismantled it but there is no reference on the tube.
My question: do any of you know the reference of the tube used?
Thank you in advance for your help.wink

regards from Belgium

denisio

Showing 1 response by yogiboy

Any 6922 or 6DJ8!

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION No sound, meter lights are not on • Power cord disconnected • Power off at source • Fuse blown • Connect power cord • Check AC source • Check fuse No sound, meter lights are on • Interconnect not properly installed • Preamp set to wrong source • Bandwidth switch not activated • Power amp off • Tube failure • Check installation of interconnects • Turn preamp to tuner • Activate one of the bandwidth switches • Turn on amp • Replace tubes (MD Reference 6922) Signal strength is low • Antenna not connected • Wrong type of antenna • Station too far away • Antenna pointed the wrong way • Check antenna hookup • Check instruction manual for types of antennas • Change your antenna • Rotate the antenna to point at the station Reception is poor • Antenna not connected • Wrong type of antenna • Cross talk from neighboring stations • Multi-path is occurring • Antenna switch on wrong setting • Check antenna hookup • Check instruction manual • Switch to narrow setting on IF bandwidth • Rotate your antenna, read the Reception Techniques • Check antenna input setting Intermittent sound • Mute switch is on • Turn mute switch off