Macintosch 8950 or parasound a21


I was looking for some advise on a new amplifier .I currently have a Line magnetic 508 1 A  tube integrated ,with a Aurender A10 Dac.I have a pair of klipsch Forte 3s and a pair of Tekton double impacts.The Klipsch sound a little fatiguing on the top to my ears sometimes ,I’m sure a lot of this probably has to do with my room.. I was wanting to try out a pair of 1.7 magnepans sometime in the future. I have admired the Mac equipment and considered trying out one of the integrated pieces and have heard good things about the 7200 integrated but was thinking if I went the Mac route the 8950 ,or the Ma 352 would be a better choice for me.I was told by a local guy that the parasound JC 2 BP with a a21 would sound good with my klipsch ,tektons and Maggie’s.I was curious if anyone has experience with this combo or the Macintosh 8950  or ma 352  and would  the Mac sound good with these speakers also?

Thx for help

bobster50

@bobster50 

There is a pretty significant difference between the MA8950 which is a transformer coupled (Autoformer) design versus the MA252 and 352 which are direct coupled. The vast majority of tube amps are transformer coupled due to the fact that high output impedance necessitates it. However, Solid state amplifiers don't suffer the same challenge and rarely employ output transformers. To my knowledge, McIntosh is the only company currently producing them. The advantage to having an output transformer is that the design can be optimize for one consistent, predictable impedance. The different taps represent longer windings, but all speakers (taps) will see the amp's potential output, not just lower impedance options. There are downsides - a large transformer (lots of copper) in the signal path, weight, and especially cost. McIntosh produces Autoformer in house and they're good at it.

While I will stop way-short of saying that transformer coupled solid state amplifiers are inherently better than direct coupled designs, McIntosh has honed the craft which is why all of their top solid-state models employ it. And since many people love tube amps and part of what you're hearing is the quality of the output transformer, it stands to reason that Autoformer amps may share a bit in common sonically with their tube counterparts.

To my ear, recent Autoformer McIntosh amps share the quality of being somewhat smooth sounding. My MC462 has a mild bottom-up presentation, it's dead-quiet and it's utterly smooth across the entire frequency spectrum. 

So, long story short - The MA8950 doesn't possess the mildly dryish qualities I've heard from the MA252 and 352. It sounds more like the 462 to me and I think most who have listened to enough Mac gear would probably agree. 

As for tubes on "harder-to-drive speakers," there is a consensus that they can't do it, but I've been surprised in the past. The Forte III, IMO, wants current. The little Maggie 1.7, while lower in sensitivity and impedance, is different. I once drove a pair of Martin Logan Aerius i with a Canary 300B amp and was surprised by how well it worked. I also had a dealer near me who made a career of driving Maggies with tube amps. He was quite "eclectic" but also brilliant. People in the industry were hard on him, in part because he was different. But I heard a few of his systems personally and I think that if others had, they may have struck a different tone. 

OP- you might give some credence to the advice of @erik_squires and also @russ69. Both have lots of cred. They are offering you excellent advice based on decades of experience. 

You admitted the problem is probably the room.

Get the room and setup right, then play around with gear swaps.

@bobster50 

To be fair to others, the room is pretty much half of what you hear. I've been in business for 20 years and in the industry for more than 30. I heard very nice gear sound bad and modest gear sound good, all depending on the room. It can be hard to "fix" a living space with treatment without impacting a room's aesthetic though. We deal with the balance between form and function in the Custom Integration business every day.

NAD is including Dirac Live in their top-of-the-line Master Series. Anthem has ARC in the STR line and Martin Logan leverages ARC in their top Hybrid ESLs. Even McIntosh has the MEN220 which borrows Lyngdorf RoomPerfect from Steinway Lyngdorf. All are high-end solutions designed to address issues with listening spaces through DSP. 

You may be dealing with a few challenges here. Room, synergy and tastes. I don't see a problem experimenting with any and all. But buying a MA8950 is an expensive "experiment" and that may be the underlying message from some of the commenters here. 

 

No worries! I appreciate  your help .I wasn’t  ready to run out and buy anything I was just asking opinions.I think I am going to stop here not liking the vibe from some of sound engineers that feel need to chime in on advise that was not asked for ,not even knowing what my rooms looks like.