Krell KSA 200B and Musical fidelity F22????


Hi Folks,

Krell KSA 200B and Musical fidelity F22…Will it work???…Good combination?????

I’m looking to buy a KSA 200B to power my B&W 801 matrix series lll speakers, I’ve got a Musical fidelity F22 hybrid pre amp which has a valve output stage….will this pre work with the KSA 200B? if so prior to using a tube preamp do I have to activate the coupling capacitors, is this a requirement for the KSA 200B?.

Also what do I need to look out for when I audition the KSA 200B to ensure I get a well-maintained amp?

Any advise, comments will be much appreciated.

My thanks in advance.

Danny Sangha
daljitsanghaf43b
When I was a Krell dealer in the 80s I often used a hybrid preamp with KMA 100 and KSA 100 and others of that era. Given a properly designed and operating preamp it is hard to see any trouble. Krell's reluctance to recommend tube units apparently stemmed from the DC leakage problem mentioned earlier.
You probably should ask Krell some of these questions. Generally, I had no problem when I used my Krell KSA 80 (the smaller stablemate of the 200) with an Audio Research SP11 Mk II hybrid preamp. As far as maintenance, you could get the serial number and ask Krell if the unit's been back for repairs, as I think they keep that sort of information. I would also recommend sending the unit to Krell for them to go over it, if you do buy it--they would replace the caps, which I understand they recommend at this point given the unit's age and should run in the $4-500 range, if I recall, but the nice thing about high-end companies such as Krell is that often they'll replace other, smaller items for little or no charge while they're performing their contracted repairs.
You could get a meter and check for DC leakage from the preamp before connecting it to the amp. You should only need the coupling capacitors if there is any leakage.