KLEI Absolute®Harmony Phono/RCA Plugs

Definitely no ad... I have tried their Copper, Silver and Pure rca plugs and I find them to be excellent. I guess I am just excited with the release of the Absolute Harmony rca plug and you aren't... that's ok :)

I will let you know what I think of them in the future when I try them :)

Williewonka, the Absolute Harmony RCAs and the gZero10s sound pretty amazing! Is that how you are finding them :)

Williewonka, wow, sounds like they transport you right through the Pearly Gates to Heaven :)

Would you say the 10s are as good, or better than, more expensive ICs that you have had in your system or other systems?

Have you compared the Absolute Harmony RCAs to other RCAs or even the Pure Harmony RCAs? Are they better, much better, from your experience...

Williewonka, I look forward to reading the review...

Williewonka, what other RCA plugs have you used so far on your DIY interconnects...

I have tried the following RCA's on my DIY cables and found each one in the list to perform discernibly better than the one before it...
- Canare
- Furutech with copper centre pin
- Eichmann Silver Bullet
- Copper Harmony
- Silver Harmony
- Pure Harmony
- Absolute Harmony (currently burning in)

I also replaced the Nakamachi RCA's on my silver litz one-piece tone-arm wire with the Pure Harmony and the improvements were staggering. They convey so much more information with a very neutral presentation. Again, they allow for more clarity, better and deeper bass, larger image etc...

ok, got it :)

As an example...
Installing the gZero6 speaker cables in my system had a dramatic impact on the depth, speed and control of the bass
- but what if I had been using a more “conventional” power cable at the time I installed the gZero6’s
- a subsequent upgrade of that power cable might lead most people to attribute new improvements to the upgraded power cable alone.

yes, interesting...

It wasn’t until I started assessing what the overall impacts the gZero architecture was actually responsible for, that I realized...
- the architecture of both speaker cables and interconnects actually allows attached components to work as designed, by keeping the neutral side of attached components at zero volts - which dramatically improved imaging
- the power cables I use provides the “juice” at the “speed required” to improve the dynamic response of those components
- the quality materials & connectors in both the interconnects and the speaker cables conveys a more detailed and dynamic signal from the source to the speakers.
Basically It’s a “team effort”

even more interesting...

Williewonka, well done, very nice read :)

Theoretically, the return/ground should be 0 volts but as your article indicates, it never really is and the resulting noise must colour the signal sound, as you have shown! ... very nice read :)