Isolation Transformer OR Power conditioner


HI
I have a pair of tube monoblocks that i'm plugging into a power bar for now (limited outlets) but looking to upgrade my power situation

Dedicated lines is not an option at this time
My digital is currently being plugged into a balanced conditioner

I need your help in determining what's best for my setup
Mainly my Tube monoblocks
musicfile
As much as I hate to admit it, PS Audio has a new, very inexpensive filter system out that, according to a very trusted friend, is just amazing. http://www.psaudio.com/products/duet_power_center.asp
It has both common and differential mode filtering and 'unlimited' current supply. I haven't compared it to my beloved balanced power but, I have built similar power filters and found them to be quite impressive!
140 watts

Gordus are you leaning towards this PS Audio unit as well
Does it throw a lot of heat
I don't trust PS Audio nor any manufacturer that does not publish noise reduction specs. That's something very measurable.

I have used DeZorel from Yugoslavia and they make KILLER power filters with guaranteed specs & tolerances. Their downloads section has good info:

http://www.dezorel.co.yu/

***
Spec's on a component aren't worth much unless the spec's themselves offer quite a bit of info as to how they were derived and what the test conditions / parameters were. With that in mind, i remember Psychic forwarding me a link to Dezorel's website. If i remember correctly, these were toroidal based units and inferior to a good quality isolation transformer by some 35 - 55 dB's or so. Since a difference of 10 dB's is equivalent to one tenth the noise floor, and we are talking about 3x - 5x that amount of potential noise attenuation, we are talking about a pretty huge difference here.

Obviously, not everyone wants to go through the hassle of hooking up an Iso the right way, so the Dezorel might work better in such a situation. It is probably far more of a plug & play device than a good sized iso.

Other than that, you need to provide more info on the devices that you intend to hook up to whatever it is you end up buying. I would also recommend checking the archives, as this is a rather common subject that has been covered many times with some very diverse opinions being expressed. Sean
>
I have written far too much on forums and emails about iso's that have fallen on deaf ears (or blind eyes) to repeat myself.
Sean, DeZorel units do not use trannies. Never have. I almost cried when I had to return the loaner. Lak still has one, I think.
is there a us retailer
Are these the plug and play type

Sorry for the dumb questons
Psychic: I didn't remember the specifics of the Dezorel. The only time i ever saw anything on them had to do with you asking me about them and then some type of business scandal that they were supposedly later involved in.

I do remember you asking my opinion of these units, with which you then provided me with spec's. After examining the spec's, i told you that these looked to be a lower to medium grade toroidal based unit and that they probably weren't worth messing with. When you asked why, i replied that the figures were much lower than what could be achieved with a high quality isolation transformer.

At that point, you forwarded my response back to Dezorel, along with the figures that i quoted. Dezorel responded that those figures would be very hard, almost impossible to achieve. I then forwarded you the spec's on a couple of different Iso's that i was aware of and you forwarded that back to Dezorel. One of those units were the same Iso's that i had turned Lak onto, of which he had two. After Dezorel saw the spec's for these units, that was the last i ever heard from you about them.

Given that i saw nothing outstanding about these units, i pretty much never paid any attention to them. This could be why i didn't recall anything about them or the fact that they didn't use toroids, even though their spec's looked as if they did. Sorry for the confusion if my comments generated any.

Musicfile: I responded back to your email, but once again, you didn't provide the info that i was looking for. I explained what was needed in the email, along with some of the caveats of using an Iso in your specific type of installation. Sean
>
Where are you these days, Sean? In tha shoppe? I'm @ my parents' recovering from foot surgery...have some 'free' time these days to surf the net.
Unemployed and living at the parents house. You should have played George Costanza on Seinfeld instead of Jason Alexander.

All the credentials but bad timing; missed your calling by a few years.
Actually, Mr. Audiofeil, I do live rent free at my uncle & aunt's vacation cottage in the Eastern Caribbean. They were not using it anymore & I take care of their property. It's mile and a half from the beach and five miles from the rain forest. It's along a one way, one lane service road and two of the neighbors are young cops who check out their homes driving the patrol cars at any time day or night.

At first, I was sad the living room was too small to let my Modwright Swans M-1 spread their wings, but Mr. VenHaus--the wannabe--encouraged me stating that I would get great sound regardless. I finally pulled my laser ruler from the toolbox and dialed them in the nearfield. To my surprise, the near field has let my Marantz Esotec class A monoblocks work their magic. Since they're only 30W now I can hear all the microdynamics without room reflections reinforcement. Everything has a purpose. The Modwright Swans will stay near field regardless where I go...

BTW, my work e-mail ends with @dhs.gov.

You need to get a life--but first you need to learn how to be a professional.

With psychic power and primal intensity,
Well psychoanimal thanks for the help. Coming from an unemployed living with aunty kinda guy, I'll take your advice based on its' merit.

Surf's up everybody.

With a real life and gainfully employed.