2. analog
  3. 194037-174921

Impedance Loading for SS Hyperion

"470 - 1000Ω" says Peter Ledermann. My phono stage offers 400. 800, 1,200. so I used 400 initially (extremely smooth), decided 800 was better (some edge present) and 1.2k even better still. There is one higher setting allowed for the MC input (along with several lower ones), 47k. So I’m trying it, and I like it. I keep swapping to the London Reference I am comparing the Hyperion to, and it seems the higher the impedance loading, the closer they sound. I am not experiencing the "peaked high end" I was warned of if loading is increased over 1000Ω.

Maybe my half a remaining ear (thanks, streptomycin!) simply can’t hear the cartridge screeching. Might work for others with high frequency loss? I think the issue is that I have a powered sub that is making sure I hear some bass whatever the loading is set to. If I turn it off the Quad 2905 speakers alone don't sound as if I'm listening to the full range of sound. Perhaps I should set the loading without the sub, and then do my usual procedure of setting the sub volume so I cannot tell that it is switched on, but all the same things sound better?

dogberry
dogberry OP
798 posts
 

I used the Sussurro MkII ES with a VAS transformer (1:10) and enjoyed it greatly, and found no downside when I resurrected the NuVista Vinyl to using it with an input set to MC. So when I got the Hyperion I plugged it straight into the NuVista.

Prior to using SUT I had the Sussurro connected to an MC input of a Quad 24p, and that was not impressive (loading was fixed at 10Ω).

One strange thing to report, though, is that I recently had to swap in an old power amp (YBA-1ɑ) as one of my Quad II/forty amps developed a fault. The Hyperion now has a slight hum that I had not heard with the Quads. Irritating! I'm curious to see if it resolved when the Quad gets repaired.

earthtones
113 posts
 

Try lifting a ground on the amp or somewhere else? Also, not that this may directly help you in your case, but I was getting hum in the phono section with my new SUT at first. I moved it further away from my power regenerator and that fixed it.

dogberry OP
798 posts
 

I checked this morning and all four cartridges are humming, the Hyperion least of all. But I've gone from 40W amps to an 85W amp. Turn the volume down on the pre-amp dummy! Problem solved.

billstevenson
561 posts
 

It is funny how some times the simple solution is the best one.  

lewm
13,624 posts
 

Quad phono has fixed input Z of 10 ohms!!!!?  Really?

More to discover