I'm not sure... if you mean a preamp, then my experience with the ASP line was that they were a little on the warm side. Close to Parasound Halo, like the A23
but also good candidates for Parasound's P7, which worked REALLY well with mine.
ICEpower 125ASX2 front end
I'm building an amp using two ICEpower 125ASX2s bridged.
Anyone built a front end/buffer with good results?
| Output Power 1 % THD+N, 20 Hz – 20 kHz (SE) |
125 W (4 Ω) 150W (8 Ω) |
| Output Power 1 % THD+N, 20 Hz – 20 kHz (BTL) |
450 W (4 Ω) |
| Output Power 10 % THD+N, 20 Hz – 20 kHz (SE) | 150 W (4 Ω) |
| Output Power 10 % THD+N, 20 Hz – 20 kHz (BTL) | 550 W (4 Ω) |
| Minimum load impedance | 3 Ω |
| Maximum amplifier efficiency | – |
| Maximum total amp+psu efficiency | 86 % |
| Supply voltage input (Selectable) | 85-264 VAC |
| Peak output current | 20 A |
| Dynamic range (SE) | 117 dB |
| Dynamic range (BTL) | 121 dB |
| Amplifier maximum output voltage per channel | 32 V |
| Output referenced idle noise (A-weighted) (SE) |
30 µV |
| Amplifier maximum output voltage per channel | 32 V (SE) 60 V (BTL) |
| Output referenced idle noise (A-weighted) (BTL) |
36 µV |
| THD+N 1W/1kHz | 0.003 % |
1 response Add your response