@deep_333 No, they are not. This just shows you know little about even the modulation. Which is not voltage at all, btw. People moved on from AM days. TOSLINK is a laughable comparison to Ethernet. Which is completely different and does not lose any bits. And no, there is no jitter there either.
Home network router question
Hi,
A network question from an analogue brain.
Our internet provider recently transitioned to a system of hardwired modems with various pods ( Plume ) for the routers. There is one Plume/router which is hardwired to the modem and the rest are plugged into wall outlets. Unfortunately, the modem is in the built in stereo cabinet- which is less than optimal. I want to move the modem and "main pod" to another location away from the cabinet. Three questions:
1. Is running an ethernet wire from my streamer/DAC to the main pod equivalent to direct wiring to the old stand alone modem/router?
2. If I move the modem and main pod; can I run a cable from the main pod to an ethernet port ( to be installed ) in the cabinet and plug in my streamer? Will this be nearly equivalent to hard wiring into my old modem/router?
Any thoughts? Please remember when replying that I am an analogue guy trying to navigate the digital world with as little pain as possible.
PS I don't want to connect via wifi.
Thanks
MP
- ...
- 31 posts total
@rbstehno - Wired is certainly better, but sometimes it is not achievable. I think if their WiFi can handle, say, Netflix to the point, it will be fine with audio. |
I think your concerns on configuration really won’t impact the performance of your streamer. A good general rule to follow is to hardwire your devices wherever possible. Even streaming high res audio, you’re not using enough bandwidth to stress anything. As far as concerns with interference goes, it’s also a moot point. It will never be high enough to be detectable by your hearing. The entire process involves moving packets of data from a source to your device. Be it wired, wireless, power lines….it doesn’t matter. It’s all read requests followed by a data stream. A file is broken down into chunks (packets) sent over what ever, then reassembled by the client. |
A couple of years ago I went to an ASUS Mesh network for our home. The base router, an RT-AX86U sits upstairs in my den next to the Motorola cable modem. Downstairs are two RP-AC1900 Mesh nodes that are networked over the air to the main router upstairs. One node is in my wife's office downstairs that serves her wifi needs with enough range to serve our outdoor patio shelter as well. (I move my wifi pellet grill under it for our PNWet winters The other node I tried to install in the same cabinet in the living room as my hi-fi rig but it generates so much RF (Hello? Wifi!) that it made my CJ Premier 6 impossible to use. So I moved it into a bookcase across the living room and ran some quality Cat 8 from it to my streamer. Problem solved. Here's a review of the Plume system: https://www.cnet.com/reviews/plume-adaptive-wifi-system-review/ I gotta tell you, I'm not impressed on either a cost or performance basis. But getting back to your question, sorry I veered off course there, if you can I would move any RF generating gear away from your hi-fi rig. It doesn't have to be that far really. Then I'd run good quality Cat cable from your router back to your streaming device. Good luck and as always... Happy listening.
|
) It also serves our smart TV in the den.- 31 posts total