You might try to borrow a VPI SDS to see if you can adjust the voltage down after start-up to help reduce the vibration.
High quality AC turntable motor
I am looking for a high grade AC motor for my Townshend Elite Rock turntable.
The current motor is specified to run at 110v 250rpm. I reckon that it's got very little torque. I have considered the phillips and the premotec - but they appear to offer no real alternative so far as specs are concerned with what I have.
I have seen a couple of motors on the RS Online website by the likes of Berger, and Crouzet. The Crouzet motor intrigues due to it's high torque rating. my concern is whether or not it is noisy, and vibrates a lot.
Does anyone have experience with these motors? or does anyone have any suitable suggestions?
I intend to try out a few different power supplies on the deck at some point.
The current motor is specified to run at 110v 250rpm. I reckon that it's got very little torque. I have considered the phillips and the premotec - but they appear to offer no real alternative so far as specs are concerned with what I have.
I have seen a couple of motors on the RS Online website by the likes of Berger, and Crouzet. The Crouzet motor intrigues due to it's high torque rating. my concern is whether or not it is noisy, and vibrates a lot.
Does anyone have experience with these motors? or does anyone have any suitable suggestions?
I intend to try out a few different power supplies on the deck at some point.