It's called a resistor.
Help! Source Output Too High for Headphones
I'm looking for any suggestions on how to reduce the output from my source, a Sony XA5400ES CD player.
I run the CD player to my headphone amp, either a iFi Pro ican, or a Woo WA22 amp. With any of my headphones
which are high or low efficiency, high or low impedance, I can only turn the volume up 1 or 2 notches, or below 9 o'clock.
There is no volume adjustment on the Sony, unlike my Oppo 105D.
Can I put anything in-line to reduce the output?
Thanks!
I run the CD player to my headphone amp, either a iFi Pro ican, or a Woo WA22 amp. With any of my headphones
which are high or low efficiency, high or low impedance, I can only turn the volume up 1 or 2 notches, or below 9 o'clock.
There is no volume adjustment on the Sony, unlike my Oppo 105D.
Can I put anything in-line to reduce the output?
Thanks!
- ...
- 7 posts total
There is no volume adjustment on the Sony, unlike my Oppo 105D.A Goldpoint SA2 or Schiit SYS will do the trick, you can connect it in reverse if you want to use it to switch between two headphone amp. https://www.goldpt.com/sa2.html https://www.schiit.com/products/sys |
iFi iEMatch+ 3.5mm Male to Female Headphone Jack in-Ear-Monitor Audio/Optimizer/Attenuator https://www.amazon.com/dp/B08S55MPH5/ref=cm_sw_r_cp_api_glt_fabc_2303E6P2562XQB5EVKYG |
- 7 posts total