Having trouble reducing the vibrations on my turntable setup

Several "solutions have been mentioned which are really not.
Mass will not isolate a turntable from anything. It will just lower the frequency it bounces at. A massive table on a bad floor will skip just as much, sometimes worse than a light one. Concrete floors will protect you from foot fall problems but not from "house rumble." Even on a concrete floor you can feel the cement truck trundle down the street. Wall shelves might protect you from foot fall problems but they will make a lot of other problems worse. Walls vibrate like crazy and pass it right on to the turntable. Just play and song with strong bass and put your hand on the wall. Many have wound up with feedback problems. The only sure fire solution is a properly isolated turntable with a suspension tuned below 3 Hz. I would never consider a turntable without a proper suspension. If you really love the turntable you can always put a MinusK suspension under it. Sonically you can not do better. It is not the most user friendly solution.
With turntables like the Sota the suspension is internal floating a sub chassis. You can rest your hand on the plinth no problem. With tables like the SME and one sitting on a MinusK platform if you put your hand down on the plinth the whole thing starts bouncing. The SME is at least well damped. The Dohmann has an internal MinusK system and is bouncy but for certain is one of the very best sounding turntables made and the only one at this time I would opt for over the Sota if I could afford it. 

@arjunm , https://www.minusk.com/products/ct2-ultra-thin-low-height-vibration-isolation-platform.html

@arjunm , You really only have two good, sure fire ways around this problem. 1st is a MinusK platform. 2nd is getting a fully isolated , suspended turntable like the SOTA, SME, Basis, Oracle, or Dohmann. 
Other less effective solutions exist but if a device does not ask for or accommodate the weight of your turntable forget it. It will not work. To isolate the turntable it has to be suspended by springs with a resonance frequency below 3 Hz. In order to tune the suspension correctly the weight of your turntable needs to be known. The Master Solution is an expensive turntable and would warrant the price of a MinusK platform. They make a low profile one now about $5000. Just a warning, things are going to get a bit bouncy. You get use to it. I will make a significant improvement in sound. Once on the platform absolutely nothing will bother the turntable including jumping up and down and kicking the stand.