glass shelves under components?

thanks to all for your responses

Do like I did, get some custom made acrylic shelves. 1/2" acrylic that is 19" x 20" ran about $210 total for 4 shelves. That's $55.00 each with a polished front edge. You could also get 3/4" thick, that ran about $70.00 per shelf. Inexpensive compared to some isolation devices that would have to be put under each component.

Glass may look great but it creates many sonic problems.
Try putting a sound absorbent board under a unit. Very inexpensive is something that Tandy Leather carries. It is called 'Poundo Board'. A 12" x 24" piece sells for about $11.
While its clolor is red, it works wonders.

I had a glass shelf rack at one time and on the advice of a friend tried a very simple solution that worked for me. I purchased some 12" bicycle inner tubes at Wal Mart, one for each component. I inflated them so they would slightly flex under the weight of each component and placed them between the shelf and component. Experiment with the amount of inflation and placement till the component sits level. It was ridiculously inexpensive and worked quite well.

Try Herbie's Audio Lab Tenderfoot or Iso-Cup footers between your equipment and your glass shelves. I've had very good results with these in a similar situation with a Sound Organisation rack with glass shelves. I may eventually replace the glass with maple shelves, but for now Herbie's footers seem to be the best solution. I've used them under digital sources and amplification equipment including Audio Note. You can find them at: Herbie's Audio Lab Footers

There are very few absolutes when it comes to shelves, footers, etc. It is very system dependent. Ask enough people and you will get as many answers as there are possible shelving systems.

You get "Glass would be a worse case scenero" but Naim makes a very highly regarded rack that uses glass shelves as do others.

Sorry, you will have to experiment.

My preference for most effective electronics isolation is to use sorbothane directly between the component and the shelf. I ditched the cones long ago - they are metal and metal transmits high frequency vibrations from shelves. Glass would be a worse case scenero. If you want to try DIY try making some sandwich footers consisting of one layer of soft wood, one layer of sorbothane, and the last layer of hard wood. Its probably over kill but it might look better than just sorbothane pucks etc. If you want you could still use the glass shelf in lieu of the hardwood as support, but covered with sorbothane (partially or totally) and put a second soft wood shelf directly under your component. FWIW.