IMHO, the phono preamp is the most important link in the audio component chain. Enjoy it!
From DV P75 MKIII to Parasound JC3+
If your interested in my full gear see the system link below.
In short I replaced my DV P75 MKIII with a JC3+. I run a VPI Scout Turntable with a DV 20x2L cart. I have the initial loading at 100 Ohms.
Initial impressions with only a couple hours on the new JC3+. Smooth, natural sound with extended highs and a good grip on bass. Instruments seem more rounded and complex/textured. Openness is about the same as the DV so far, but that may just require break in to open it up. Mind the DV was pretty open. The gain is a lower than my DV was, but the unit is very quiet so turning up the volume from its original set point fixes that.
No hum to speak of.
I will,enjoy the break in process, though I'm not sure how long I should anticipate.
So far so good. I'll report back once I've run the gear in.
In short I replaced my DV P75 MKIII with a JC3+. I run a VPI Scout Turntable with a DV 20x2L cart. I have the initial loading at 100 Ohms.
Initial impressions with only a couple hours on the new JC3+. Smooth, natural sound with extended highs and a good grip on bass. Instruments seem more rounded and complex/textured. Openness is about the same as the DV so far, but that may just require break in to open it up. Mind the DV was pretty open. The gain is a lower than my DV was, but the unit is very quiet so turning up the volume from its original set point fixes that.
No hum to speak of.
I will,enjoy the break in process, though I'm not sure how long I should anticipate.
So far so good. I'll report back once I've run the gear in.
2 responses Add your response