The only thing a tube tester can tell you is whether a tube is worn out or nearly so. That you can determine by comparing the manufacturer data to the tube tester result. But the red flag is transconductance. As tubes wear, transconductance goes down, for any given bias and plate voltage. Consult an RCA tube manual or any of several websites to download the pdf file for the tube under investigation. These are very old data from manufacturers that no longer exist or no longer make tubes, but the numbers are still valid ways to evaluate tube condition. If the measured Gm (transconductance) is below the range of values given for a given bias and plate voltage, then the tube is worn or wearing out. Yet, as Larry said, that tube may still sound "good". Better test is to replace such a tube with a new one and then listen. If you hear improvement in terms of a livelier sound or better treble and bass response or a sense of better gain character, dump the worn tube or save it for a spare.
The Chinese-made fake ECC81/12AT7 often are labeled as "801S", just to make them look even more desirable. On the other hand, these fakes often sound fantastic. I compared about 6 different NOS 12AT7s in the input stage of my Atmasphere amps, many years ago. Other than the Chinese made 12AT7s, all the other tubes were true Euro or US NOS brands such as Amperex, Sylvania, Mullard, GE, etc. The Chinese tubes sounded by far the best. I bought them from Billington in the UK, and they were openly sold as Chinese tubes under the label "Billington Gold" (they had gold pins); there was no attempt to mislabel them as TFK or anything like that. The downside of those Chinese 12AT7s was only that they had a short lifespan compared to true NOS tubes. I used them anyway for a while.